ASP STERRAD 100, Service Manual, Page: 126 / 309

Cycle Parameters
SHORT CYCLE
(default)
Editor selections: Long Cycle = NO
Elapsed Time = 55 minutes, Double injection
LONG CYCLE
Editor selections: Long Cycle = YES
Elapsed Time = 72 minutes, Double injection
Upon installation, the cycle defaults to
SHORT CYCLE
. If this is not
changed in the editor, pressing
START
while the system is idle give you
a confirmation of that cycle. Pressing
CANCEL
changes the choice to a
different cycle. Once a different cycle has been selected in the editor, the
choice remains in effect until changed, or until the Total Machine Cycles
are reset to 0 (this sets the cycle to the default).
Enter the Edit Mode-STERRAD 100 S Systems
1. To enter the EDIT mode, press
CANCEL.
2. Press and hold
CANCEL
and simultaneously press
START
. This
opens the Date-Time menu.
DATE = DAT MM/DD/YY
OPEN(chng)- CLOSE(accept)
3. Simultaneously, press
START
and
OPEN DOOR
for 5 seconds to
view and edit the process parameters. The system displays the serial
number with a flashing cursor in the serial number field. Setting the
serial number is shown in the following procedure.
SERIAL NUMBER 0
OPEN (chng)- CLOSE(accept)
4. Press
CANCEL
to move sequentially through the available menus.
Setting the Total Machine Cycles-STERRAD 100 S
Systems
1. Note the total machine cycles and the serial number.
2. Press CLOSE DOOR about 4 times to move the cursor to the 5th digit
field.
3. Press CANCEL to change the fields. The total machine cycles should
be displayed. The total machine cycles menu looks like this:
TOTAL MACH. CYCLES XXXXX
OPEN(chng) - CLOSE(accept)
XXXXX represents the total machine cycles run.
User Interface Calibration User Interface and Control Subsystems
ASP Service Guide rev D. STERRAD® 100 Sterilizer 6-13