Altigen ACC 6.7, Administration Manual

Page: 271 / 462

MAXCS ACC 6.7 Administration Manual 257
C
H A P T E R
20
Paging Group Configuration
The IP paging group is a group of IP phones that can receive station paging. This feature
also can be used as IP zone paging by creating multiple paging groups.
Implementation details:
•
The paging signal uses AltiGen's proprietary H.323-ATPS protocol. You need to have
H.323 tie-trunk channels to be able to implement IP paging.
• Each paging session requires one G.711 codec channel. The voice stream is multicast
to multiple IP phones on the LAN.
•
Any extension (analog or IP) can initiate a paging call by dialing #46 + the Paging
Group number.
• When paged, an IP phone in idle state will automatically turn on the speaker, play a
beep, and then play the page.
•
When receiving an incoming call during a paging session, the IP phone will
automatically stop the paging session and start ringing.
• The IP phone user can terminate a paging session by pressing the Release key on
the phone.
•
IP phones in DND mode will not be paged.
To configure paging, select PBX > Paging Group Configuration .
Figure 122. Paging Group Configuration window