Altigen ACC 6.7, Administration Manual

Page: 161 / 462

Chapter 12: Trunk Configuration
MAXCS ACC 6.7 Administration Manual 147
To activate a trunk paging port, dial #45 and the ID number. For example, a user
dials
#4508
to connect to a paging system through the trunk with paging ID of 08 .
The Trunk Paging option and the Overhead Paging option (in “Audio Peripheral
Configuration” on page 63) are different and independent of one another. The
Overhead Paging option is to set up the Audio Out port on the telephony board
and uses
#44 to activate.
The E911 option is exclusively for an analog Centralized Automatic Message
Accounting (CAMA) trunk connecting to a Triton analog trunk board. CAMA trunk
is a special type of trunk from your carrier for E911 service. When an analog trunk
port is assigned as an E911 CAMA trunk, the system will send the station
identification number, defined in the extension configuration E911 CID field, to
the PSAP via multi-frequency signaling. The E911 CID is needed to:
•
Allow PSAP to identify the caller's information and exact location by matching
the Automatic Location Identifier database in PSAP.
• Have the callback number in case the call is disconnected.
Note: Do not select the E911 option for a T1-CAS or PRI trunk. T1-CAS cannot
transmit the ID. PRI trunk will transmit calling party's ID automatically.
When the E911 option is checked, this trunk will no longer receive inbound
calls, and only 911 calls will go out through this trunk.
Each state may have different E911 regulations and requirements. Please
check with the local authority to understand what is required by law.
• Phone Number —If this trunk is an analog or T1-CAS trunk, this field is used for
labeling purposes only. Enter the number without area code in this field. If this trunk
is a PRI trunk, the system will output this number to the carrier as the calling party
CallerID.
PRI trunk transmitting caller ID rules:
1.
If extension has Transmitted CID configured, this number will be transmitted
first. If not configured, go to next.
2. If extension has DID Number configured, the 10-digit DID number will be
transmitted. If not configured, go to next.
3. If PRI trunk channel has area code and caller ID configured, this number will be
transmitted. If not configured, go to next.
4. PRI will transmit the system home area code and main number defined in
System Configuration,
General tab.
•
Description —Descriptive information such as the company name for the assigned
Phone Number, or appropriate agency if this trunk provides 911 access.
• Trunk Dialing Scheme —Overlap or En-bloc dialing.
• Overlap - Transmitting dialed DTMF digits to the CO without buffering digits in
the system first. Use Overlap dialing for analog and T1-CAS trunks for best
results. Calls will be completed faster.
• En-bloc - The system will buffer all dialed digits and send it to the CO at once.
Typically is used in ISDN-PRI trunk and SIP trunk.
Note: For IP tie trunks, use the IP Dialing Table in AltiEnterprise Manager to set the
dialing scheme (AltiEnterprise Manager is available by selecting
VoIP >
Enterprise Network Management , or from the Windows Start menu).