Trumpf LASERCELL 1005, Operator'S Manual

Page: 186 / 645

4-26
Operation
B337ENE4_1
Control element Prerequisites Explanation
BEAM TRAP
OPEN/SHUT
Service mode is active.
Laser beam is switched off.
The beam trap is opened or closed by
pressing this button.
Button lights up if the beam trap is
open.
LASER
LASER RESET
None Error messages are acknowledged
after eliminating the error by pressing
this button.
The execution of an active program can
be resumed with START.
Button flashes if an error is present at
the laser control system.
BEAM ON/OFF
Service mode is active.
The beam trap is closed.
Beam block is not active.
The laser beam is ignited or switched
off by pressing this button.
Button is lit up as long as the beam is
ignited.
LASER
TEST
LASER TEST
FEED HOLD is not active. The LASER test mode is activated or
deactivated by pressing this button.
In LASER TEST mode, the laser beam
and the cutting gas are switched off. A
part program can be thus be executed
without the laser beam being ignited.
LASER TEST is activated automatically
if the TEACH PANEL key switch and
the TEACH PROBE switch element are
set to on.
Button is lit up in active LASER TEST
mode.
PROGRAM
START
The home position is established.
FEED HOLD is not active.
Machining program has been selected.
The selected machining program is
started by pressing this button.