Trumpf LASERCELL 1005, Operator'S Manual

Page: 424 / 645

B337EN05.DOC
Checking and setting B and C axes
5-11
The B axis is set mechanically.
1
1 Securing screw and clamping
screw for friction clutch
Rear view of the B/C angular gear
1. Unscrew the securing screw (SW4).
2. Move the B axis in jog mode until the BS mark corresponds to
the reference mark on the B/C angular gear.
3. Undo the clamping screw for the friction clutch in the B/C
angular gear until the C axis can be turned (with difficulty) by
hand.
4. Select >Operation >Set-up >MDA.
5. Enter B0.
6. Press Start.
The B axis travels to 0.
7. Move the X axis slowly in jog mode, enabling the pointer of
the measuring probe to the reference area. While doing so,
check the display on the measuring probe.
8. Turn the B axis by hand until the difference is less than
0.02 mm.
Setting the B axis
Fig. 32552