2-44
Installation conditions TLC 1000 and TLC 1005 - Version 5
B337EN02.DOC
Time before
delivery of the machine
Planning criterion
Action
12 weeks,
but no later than calendar week ...
Gas supply
Arrange for installation of the
laser and cutting gas supply at
the installation site.
Decide on the gas supply
method (cylinders, cylinder
bundles, gas tank).
Note the valves and fittings
required (e.g. two-stage
pressure reducer).
Consult your gas supplier to
make a layout for the gas lines.
12 weeks,
but no later than calendar week ...
Compressed air supply
Install a compressed air supply
at the installation site
(connection, purity, compressed
air requirements).
4 weeks,
but no later than calendar week ...
Working materials
Acquire stocks of operating
materials:
laser gases, cutting gases, and
operating materials for the
cooling unit.
4 weeks,
but no later than calendar week ...
Transport
Make sure that the transportation
aids required are available.
2 weeks
but no later than calendar week ...
Prepare
foundation
Prepare the foundation (bore
holes and cutouts) of the
machine according to the
foundation plan.
At installation and start-up
Ensure electricians are
available
Connect the machine to the
electrical supply.
In the course of installation
by the servicing technician
Transport
A crane must be available for
installing raised machine bodies
and machines with two station
operation.
Table 2–29
Summary of Contents for LASERCELL 1005
