Trumpf LASERCELL 1005, Operator'S Manual

Page: 243 / 645

B337EN4_3
Operation
4-83
Fig. 39428en
11
Applies to machines with AutoLas Plus. This parameter is not required for machines without AutoLas Plus.
Marking
•
AutoLas Plus
11
setting dimension: AutoLas Plus setting
dimension in mm. States the position of the focus relative to the
nozzle tip during piercing. The dimension is set automatically
via the AutoLas Plus facility.
•
Nozzle distance: distance between the lower edge of the
nozzle and the material surface in mm.
•
Laser output: output of the laser in watts with which the
programmed machining will be carried out. This parameter is
not effective if TC_ACL is programmed for channel 1.
•
Gating freq.: frequency in Hz with which the laser works
(100 – 99000 Hz). This parameter is not effective if TC_ACL is
programmed for channel 2.
•
Cutting speed: speed in m/min at which the programmed
contour will be cut.
•
Gas type:
-
0 = no gas.
-
1 = oxygen (O
2
).
-
2 = nitrogen (N
2
).
-
3 = laser gas (customized).
•
Gas pressure: programmed gas pressure in bar with which the
cutting gas is emitted during contour machining.