Trumpf LASERCELL 1005, Operator'S Manual

Page: 372 / 645

4-212
Operation
B337EN4_8
12.3 Referencing the safety door
The doors can be referenced in any position. The door is first
opened completely during the reference run. The door is then
closed. This procedure is repeated until the reference run is
successful. A message is displayed on the control panel as long as
the door has not been referenced.
Select SET-UP > Switch elements > Safety doors ....
Set "Reference safety door" to on.
Press TOGGLE.
The reference run is carried out. The switch element display
switches to Referenced as soon as the reference run has been
carried out successfully.
Or while the control system is started up:
and
As soon as the button.
Machine ON/OFF flashes:
press OPEN and CLOSE simultaneously.
The reference run is carried out. The "Reference safety door"
switch element switches from Active to Referenced as soon as
the reference run has been carried out successfully.
Note
The electrically driven safety doors with the MxP101 drive system
from Landert are equipped with a microprocessor-controlled drive.
This means the travel data (start and end position) and the speed
profile are saved internally for each movement in order for the
sequence of motions to be continuously optimized in a dynamic
way.
Referencing
(calibration run)
The electrically driven loading doors must be referenced. The
distance between the two final positions is measured during the
referencing run. The referencing run is necessary:
•
After the MAIN SWITCH has been switched on.
•
After a power failure.
•
After a software RESET of the door drives themselves (not
after a machine RESET).
•
After triggering the fuses for the safety door drive in the switch
cabinet.
Prerequisite
•
The machine is ready for operation. The MACHINE button
flashes.