Trumpf LASERCELL 1005, Operator'S Manual

Page: 484 / 645

B337EN05.DOC
Determining the joint offset
5-71
1. Evaluate the pairs of lines for the X and Y direction:
–
Select the pair of lines which coincide precisely.
–
Enter the corresponding engraved numerical value in the
mask.
2. Press Adopt.
The determined joint offset values are saved to the data
management.
Note
To check the setting: start the program once again.
7.2 Determining link offset of Z axis
(tool length)
Z
1
E
F
F Reference value F
E Sheet upper edge up to the
reference area for dimension E
Z Offset value for Z axis
1 Reference area for bottom edge
of Al housing
Z axis joint offset
The reference value F is the distance between the reference area
and the beam center in Z direction. It is a structural dimension:
Processing optics Reference value F
Cutting head 3.75" 66 mm
Cutting head 5" 46 mm
Cutting head 7.5" 61 mm
Welding head 39 mm
Reference value F
Evaluating the pairs of lines
precisely
Fig. 23478
Reference value F
Table 5-13