R&S SMJ100A, Operating Manual

Page: 570 / 874

Remote Control Commands
R&S
®
SMJ100A
554 Operating Manual 1403.7458.32 ─ 14
The properties of the LF output connector are set in the SOURce:LFOutput Subsystem
system.
:OUTPut<hw>:AFIXed:RANGe:LOWer?
........................................................................... 554
:OUTPut<hw>:AFIXed:RANGe:UPPer?
............................................................................554
:OUTPut<hw>:AMODe
................................................................................................... 555
:OUTPut<hw>:BLANk:LIST:STATe
.................................................................................. 555
:OUTPut:BLANk:POLarity
............................................................................................... 555
:OUTPut<hw>:IMPedance?
.............................................................................................555
:OUTPut<hw>:PROTection:CLEar
................................................................................... 556
:OUTPut<hw>:PROTection:STATe
.................................................................................. 556
:OUTPut<hw>:PROTection:TRIPped?
..............................................................................556
:OUTPut<hw>[:STATe]
...................................................................................................557
:OUTPut<hw>[:STATe]:PON
........................................................................................... 557
:OUTPut:USER<ch>:SOURce
.........................................................................................557
:OUTPut<hw>:AFIXed:RANGe:LOWer?
Queries the minimum level which can be set when the attenuator is fixed, see
:
OUTPut<hw>:AMODe
.
Return values:
<Lower> float
Increment: 0.01
Example: OUTP:AFIX:RANG:LOW?
queries the minimum level for the FIXed setting.
Example: Response: -50
The minimum level is -50 dBm.
Usage: Query only
Manual operation: See "Fixed Range (PEP) In" on page 219
:OUTPut<hw>:AFIXed:RANGe:UPPer?
Queries the maximum level which can be set when the attenuator is fixed, see
:
OUTPut<hw>:AMODe
.
Return values:
<Upper> float
Increment: 0.01
Example: OUTP:AFIX:RANG:UPP?
queries the maximum level for the FIXed setting for the RF out-
put.
Example: Response: -27
The maximum level is -27 dBm.
Usage: Query only
Manual operation: See "Fixed Range (PEP) In" on page 219
OUTPut Subsystem