R&S SMJ100A, Operating Manual

Page: 821 / 874

Remote Control Commands
R&S
®
SMJ100A
805 Operating Manual 1403.7458.32 ─ 14
Example: SWE:FREQ:MODE AUTO
sets the triggered sweep mode, i.e. a trigger is required to start
the sweep.
TRIG:FSW:SOUR SING
sets the "Single" trigger mode, i.e. a trigger starts a single
sweep.
TRIG:FSW
starts a single RF frequency sweep.
Usage: Event
Manual operation: See "Execute Single Sweep - Frequency Sweep" on page 265
:TRIGger<hw>:LFFSweep
Usage: Event
Manual operation: See "Execute Single Sweep" on page 257
Immediately starts an LF frequency sweep.
The command is effective in sweep mode "Single" (
LFO:SWE:MODE AUTO
in combina-
tion with
TRIG:LFFS:SOUR SING
).
:TRIGger<hw>:LFFSweep:SOURce <Source>
Sets the trigger source for the LF sweep. The trigger is triggered by the com-
mand
:SOURce:LFOutput:SWEep[:FREQuency]EXECute
.
The names of the parameters correspond directly to the various settings under manual
control. SCPI uses other names for the parameters; these names are also accepted by
the instrument. The SCPI names should be used if compatibility is an important consid-
eration.
An overview of the various names is given in the Table 7-3 .
TRIGger Subsystem