R&S SMJ100A, Operating Manual

Page: 602 / 874

Remote Control Commands
R&S
®
SMJ100A
586 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Delay> float
Range:
0 to depends on other values
Increment: 0.001
*RST:
0
Default unit: Symbol
Example: BB:ARB:TRIG:OUTP2:DEL 16
sets a delay for the signal on connector MARKER 2.
Manual operation: See "Marker x Delay" on page 389
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MAXimum?
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MINimum?
The command queries the minimum marker delay for set-
ting
:BB:ARB:TRIGger:OUTPut:DELay:FIXed ON
.
Return values:
<Minimum> float
Range:
0 to 16777215
Increment: 1E-3
*RST:
0
Example: BB:ARB:TRIG:OUTP:DEL:FIX ON
restricts the marker signal delay setting range to the dynamic
range.
BB:ARB:TRIG:OUTP:DEL:MIN
queries the minimum of the dynamic range.
Response: 0
the minimum for the marker delay setting is 0 samples.
Usage: Query only
Manual operation: See "Current Range without Recalculation" on page 389
[:SOURce<hw>]:BB:ARBitrary:TRIGger:RMODe?
The command queries the status of waveform output or all trigger modes with ARB on.
Return values:
<RMode> STOP | RUN
RUN
The waveform is output. A trigger event occurred in the triggered
mode.
STOP
The waveform is not output. A trigger event did not occur in the
triggered modes, or waveform output was stopped by the com-
mand
:BB:ARB:TRIG:ARM:EXECute
(armed trigger modes
only).
SOURce Subsystem