R&S SMJ100A, Operating Manual

Page: 405 / 874

Instrument Function
R&S
®
SMJ100A
389 Operating Manual 1403.7458.32 ─ 14
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
on page 593
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern
on page 592
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:OFFTime
on page 591
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:ONTime
on page 591
Marker Delay
The delay of the signals on the MARKER outputs is set in the"Marker Delay" section.
Marker x Delay
Enters the delay between the marker signal at the marker outputs and the start of the
frame or slot.
The input is expressed as a number of symbols. If the setting "Fix marker delay to
dynamic range" is enabled, the setting range is restricted to the dynamic range. In this
range the delay of the marker signals can be set without restarting the marker and sig-
nal.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay
on page 585
Current Range without Recalculation
Displays the dynamic range within which the delay of the marker signals can be set
without restarting the marker and signal.
The delay can be defined by moving the setting mark.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MINimum?
on page 586
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MAXimum?
on page 586
Fix marker delay to current range
Restricts the marker delay setting range to the dynamic range. In this range the delay
can be set without restarting the marker and signal.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut:DELay:FIXed
on page 585
Clock Settings
The "Clock Settings" is used to set the clock source and a delay if required.
Clock Source
Selects the clock source.
"Internal" The internal clock reference is used to generate the symbol clock.
Baseband Signal - Baseband Block