R&S SMJ100A, Operating Manual

Page: 246 / 874

Instrument Function
R&S
®
SMJ100A
230 Operating Manual 1403.7458.32 ─ 14
on page 233). The filling of the user correction list with measurement data is per-
formed in the ucor list editor (see
"Edit User Cor. Data - User Correction"
on page 224).
In the editor, the frequencies for which the correction values are to be acquired are
entered in the frequency column (either manually or by means of the "Fill..." menu).
Do not save the list at this point, because the frequency entries are lost as long as
there are no entries for the level column also. In the following these entries are auto-
matically acquired by the connected power sensor.
All level correction values for the given frequency values are measured using the
Power Sensor and automatically filled in the selected list after the "Execute" button is
pressed. The list is automatically stored and recalled again after filling.
Fill User Correction Data with Sensor Settings
The "Fill with Sensor" button of the "Edit User Correction Data" menu opens the asso-
ciated menu.
This dialog describes all parameters for filling a table automatically with sensor read-
ings.
To select the sensor and determine its parameters, refer to Chapter 5.5.10.1, "NRP-Z
Power Viewer" , on page 233.
To fill the table, press the "Execute" button.
Fill User Correction Data with Sensor
Enables you to fill the table with correction data acquired by a connected power sensor
from Rohde
& Schwarz.
"Sensor" Displays connected sensors for selection.
"List To Fill" Indicates the used list file.
RF Signal and Analog Modulations - RF Block