R&S SMJ100A, Operating Manual

Page: 756 / 874

Remote Control Commands
R&S
®
SMJ100A
740 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Start> float
Range:
full frequency range
Increment: see the data sheet: Resolution of frequency setting
*RST:
1 KHz
Example: RST*
activates all presettings.
LFO:SWE:MODE AUTO
TRIG0:SOUR SING
LFO:FREQ:STAR 1 kHz
LFO:FREQ:STOP 10 kHz
LFO:FREQ:MODE SWE
LFO:SWE:EXEC
the instrument generates a single sweep cycle from 1 kHz to 10
kHz automatically after a manual trigger event occurs
(
:LFOutput:SWEep:EXECute
or
*TRG
). The step width is 1
kHz linear, with 15 ms dell time until the signal switches to the
subsequent step.
Manual operation: See "Start Freq" on page 258
[:SOURce<hw>]:LFOutput:FREQuency:STOP <Stop>
Sets the stop frequency for the LF sweep.
Parameters:
<Stop> float
Range:
full frequency range
Increment: see the data sheet: resolution of frequency setting
*RST:
100 KHz
Example: LFO:FREQ:STOP 10 kHz
sets the stop frequency for the LF sweep to 10 kHz.
Manual operation: See "Stop Freq" on page 258
[:SOURce]:LFOutput[:STATe] <State>
Activates/deactivates the LF output.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: LFO ON
activates the LF output. The settings under
LFO:FREQ
and
LFO:SWE
become effective.
Manual operation: See "State - LF Output" on page 254
SOURce Subsystem