R&S SMJ100A, Operating Manual

Page: 732 / 874

Remote Control Commands
R&S
®
SMJ100A
716 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Manual> float
Range:
full frequency range
Increment: see the data sheet: RF characteristics > Resolution
of setting
Example: SWE:MODE MAN
sets the
Step
sweep mode.
Example: FREQ:MODE SWE
sets the frequency sweep mode. The sweep start frequency is
output.
FREQ:MAN UP
triggers the next higher sweep step.
FREQ:MAN 500MHz
outputs 500 MHz RF frequency (must e within the sweep fre-
quency range).
FREQ:MAN DOWN
triggers the next lower sweep step relative to 500 MHz.
Manual operation: See "Current Freq - Frequency Sweep" on page 266
[:SOURce<hw>]:FREQuency:MODE <Mode>
Selects the frequency mode for the generating the RF output signal. The selected
mode determines the parameters to be used for further frequency settings.
Parameters:
<Mode> CW | FIXed | SWEep | LIST
CW|FIXed
Sets the fixed frequency mode.
CW
and
FIXed
are synonyms. The instrument operates at a
defined frequency, set with command
[:SOURce<hw>]:
FREQuency[:CW|FIXed]
..
SWEep
Sets the sweep mode. The instrument processes the frequency
settings in defined sweep steps. To determine the corresponding
frequency values, use the commands
[:SOURce<hw>]:
FREQuency:STARt
and
[:SOURce<hw>]:FREQuency:STOP
,
or
[:SOURce<hw>]:FREQuency:CENTer
and
[:
SOURce<hw>]:FREQuency:SPAN
and
[:SOURce<hw>]:
FREQuency:MANual
.
LIST
Sets the list mode. The instrument processes the frequency and
level settings by means of values loaded from a list.
To configure the list mode settings use the commands of the
SOURce:LIST Subsystem
*RST: CW
SOURce Subsystem