R&S SMJ100A, Operating Manual

Page: 445 / 874

Instrument Function
R&S
®
SMJ100A
429 Operating Manual 1403.7458.32 ─ 14
Phase Step
Sets the width of the step with which the phase will be changed from carrier to carrier.
The phase that is set with Phase + n* Phase Step must be within the valid value range
0° to 360°.
This setting is only available for "Optimize Crest Factor Mode" = Off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe:STEP
on page 679
Accept
Adopts the carrier range setting into the table ("Carrier Table").
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute
on page 679
Carrier Table and Carrier Graph
The lower part of the menu is used to open submenus for configuring carrier tables and
for setting triggers, markers and clocks.
Carrier Table
Calls the table for configuring individual carriers. This configuration can be checked
with the aid of the "Carrier Graph".
The table displays the settings of all available carriers. Carriers in the On state are
highlighted. All carrier parameters can be edited in the table.
The Multi Carrier CW signal is only computed when the "Accept" button is pressed.
Whenever the table contains settings that have not yet been adopted with the "Accept"
button, the background is yellow.
Note: The phase/deg settings are only valid if optimization of the crest factor is dis-
abled ("Optimize Crest Factor" = Off).
"No." This is the carrier index.
"State" Switch a carrier on/off
"Power" Sets the power of a carrier.
"Phase" Sets the starting phase of a carrier.
"Accept" Transfer the settings in the carrier table into the instrument.
Baseband Signal - Baseband Block