R&S SMJ100A, Operating Manual

Page: 43 / 874

Preparing for Use
R&S
®
SMJ100A
27 Operating Manual 1403.7458.32 ─ 14
With the aid of the "User Correction" function, a table with correction values for exter-
nal test assemblies can be automatically determined, e.g. for compensating the fre-
quency response of cables.
The power sensors are connected by inserting the male connector. To disconnect hold
the connector by its sleeve. Pulling on the sensor cable will not release the sensor con-
nector.
See also Chapter 5.5.10.1, "NRP-Z Power Viewer" , on page 233.
2.2 Rear Panel Tour
This section gives an overview of connectors on the rear panel of the instrument. Each
connector is briefly described and a reference is given to the chapters containing
detailed information. For technical data of the connectors refer to the data sheet.
Figure 2-2: Rear panel view
2.2.1 Description of the Connectors
LF
Output for internal LF modulation generator signal.
See also data sheet and Chapter 5.5.12.1, "Overview of LF Generator" , on page 253,
Chapter 5.5.12.2, "LF Output" , on page 254.
MARKER 3
Output for user-programmable marker signal 3 for triggering and control of external
devices.
Marker outputs are permanently assigned (see "MARKER 1, 2" on page 26).
Rear Panel Tour