R&S SMJ100A, Operating Manual

Page: 106 / 874

Manual Operation
R&S
®
SMJ100A
90 Operating Manual 1403.7458.32 ─ 14
●
The block diagram shows the instrument configuration, the signal characteristic as
well as the inputs and outputs used and permits interactive operation via graphics
elements. Active menus and graphs are displayed on top of the block diagram.
●
Winbar with labeled softkeys for menu display.
The block diagram in the figure below shows a fully equipped instrument.
Figure 4-1: Block diagram of a fully equipped R&S SMJ
4.2.1 Settings Displayed in the Header Section
Frequency/level settings and a few status messages (see Chapter 4.2.2, "Status Infor-
mation and Messages" , on page 91) are displayed in the header field of the screen.
The display may vary depending on the instrument's operating mode:
●
In the sweep mode, the current frequency or level of the output signal is displayed.
The status message "SweepMode" is displayed in the info line.
●
In the list mode, neither the current frequency nor level is displayed, the indication
is dimmed.
●
If user correction is active, the status message "UCorr" is displayed in the info line.
●
In the case of digital modulation, "Freq" indicates the frequency, "PEP" the peak
envelope power and "Level" the average level.
The values displayed in the "Freq" and "Level" fields include a set offset or multiplier
factor.
For more See alos
Chapter 5.5.2, "RF Frequency" , on page 201 and Chapter 5.5.6.1,
"Overview of RF Level" , on page 215.
Display