R&S SMJ100A, Operating Manual

Page: 441 / 874

Instrument Function
R&S
®
SMJ100A
425 Operating Manual 1403.7458.32 ─ 14
The buttons in the lower part of the menu open dialogs for defining carrier tables and
for configuring markers, triggers and clocks.
The carrier settings can be visualized in the graphical "Carrier Graph" dialog.
General Settings for Multi Carrier CW
The upper part of the menu is used for powering up the Multi Carrier CW signal and
calling the default settings.
State
Enables/disables the Multi Carrier CW.
Switching on this standard turns off all the other digital standards and digital modula-
tion modes.
Since Multi Carrier CW signals are computed in arbitrary waveform mode, changes to
the settings of individual carriers are not adopted until the Accept button is pressed.
This applies to the settings in the "Table Setup Assistant" section and the "Carrier
Table" dialog.
Remote command:
[:SOURce<hw>]:BB:MCCW:STATe
on page 672
Set to Default
Calls default settings. The values are shown in the following table.
Parameter Value
State Not affected by "Set to Default"
Carrier Setup
Number of Carriers 64
Carrier Spacing 10 kHz
Optimize Crest Factor Chirp
Desired Crest Factor 3 dB
Baseband Signal - Baseband Block