R&S SMJ100A, Operating Manual

Page: 420 / 874

Instrument Function
R&S
®
SMJ100A
404 Operating Manual 1403.7458.32 ─ 14
User Clock Rate
Defines the sample rate used for multi segment waveform output in case of Clock
Mode "User".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CLOCk
on page 620
Segment Marker
Defines the way the marker information within the separate segments is processed.
"Ignore" The marker information carried in the individual segment waveform
files is not considered.
"Take Over" The output waveform file contains the marker information as config-
ured in the individual waveform files.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:MODE
on page 623
Sequence Restart
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
"Disable" No additional marker is generated.
"Marker
1/2/3/4" Generates a restart marker signal at the beginning of the first seg-
ment for the corresponding marker.
Use this setting to generate a restart marker for the complete
sequence.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
on page 623
Segment Restart
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
"Disable"
No additional marker is generated.
"Marker
1/2/3/4" Generates a restart marker signal at the beginning of each segment
for the corresponding marker.
The segment begin is defined by the low-high slope of the marker.
This applies for switching between two segments as well as in case
of segment replay.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
on page 622
Baseband Signal - Baseband Block