R&S SMJ100A, Operating Manual

Page: 638 / 874

Remote Control Commands
R&S
®
SMJ100A
622 Operating Manual 1403.7458.32 ─ 14
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:DELete <Filename>
Deletes the configuration file. The configuration files are used to create multi segment
waveform files.
Setting parameters:
<Filename> string
Example: MMEM:CDIR 'D:\user\waveform'
sets the default directory.
BB:ARB:WSEG:CONF:DEL 'multi1'
deletes configuration file
multi1.inf_mswv
.
Usage: Setting only
Manual operation: See "Delete" on page 402
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:LEVel[:MODE] <Mode>
This command selects the level mode for the multi segment waveform.
Parameters:
<Mode> UNCHanged | ERMS
UNCHanged
The segments are output exactly as defined in the files.
ERMS
The segments are output so that all segments have the same
rms value.
*RST:
UNCHanged
Example: BB:ARB:WSEG:CONF:LEV:MODE UNCH
selects level mode unchanged. The segments are output as
defined in the waveform file.
Manual operation: See "Level" on page 403
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
<Mode>
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
SOURce Subsystem