R&S SMJ100A, Operating Manual

Page: 419 / 874

Instrument Function
R&S
®
SMJ100A
403 Operating Manual 1403.7458.32 ─ 14
Remote command:
n.a.
Append Blank
Adds the blank segment to the multi segment file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
on page 620
Level / Clock /Marker
The Level/Marker/Clock section provides the parameters necessary to adjust the level,
marker and clock settings for the selected multi segment waveform file.
Level
Defines the level mode for the multi segment waveform.
"Unchanged" Conserning the level settings, the segments are output exactly as
defined in the files. The "Level" display applies only to the segment
with the highest rms value. In some circumstances the remaining
segments are output at a lower level than that displayed.
"Equal RMS" Segments are output so that all segments have the same rms value.
The "Level" display applies to all segments.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:LEVel[:MODE]
on page 622
Clock
Selects the clock rate mode for the multi segment waveform.
"Unchanged" A segment is output with the clock rate defined in the file.
If segments have different clock rates, extended trigger mode "Next
Segment" allows internal segment switchovers only ("Internal" trigger
source).
Extended trigger mode "Next Segment Seamless" can only be
selected if all segments have the same clock rate.
"Highest" All segments are output at the highest available clock rate.
This mode provides very short switchover times between segments.
The time for calculating the multi segment waveform is increased
since the individual segments have to be resampled.
"User" All segments are output at the clock rate defined in "User Clock".
This mode provides very short switchover times between segments.
The time for calculating the multi segment waveform is increased
since the individual segments have to be resampled.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CLOCk:MODE
on page 621
Baseband Signal - Baseband Block