R&S SMJ100A, Operating Manual

Page: 790 / 874

Remote Control Commands
R&S
®
SMJ100A
774 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Source> INTernal | EXTernal
INTernal
The internally generated rectangular signal is used for the pulse
modulation. The frequency of the internal signal can be set in
the
SOURce:LFOutput
subsystem.
EXTernal
The signal applied externally via the EXT MOD connector is
used for the pulse modulation.
*RST:
INTernal
Example: PULM:SOUR INT
selects the internal modulation source.
PULM:STAT ON
activates the pulse modulation.
Usage: SCPI confirmed
Manual operation: See "Source" on page 252
[:SOURce<hw>]:PULM:STATe <State>
Activates the pulse modulation.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: PULM:STAT ON
activates pulse modulation.
Manual operation: See "State" on page 252
7.16.17 SOURce:ROSCillator Subsystem
This subsystem contains the commands for setting the external and internal reference
frequency.
The settings of the reference oscillator are not affected by an instrument reset (
*RST
on page 486). They are only reset to factory state by the factory-preset (
:SYSTem:
FPReset
on page 489).
[:SOURce]:ROSCillator:EXTernal:FREQuency
..................................................................775
[:SOURce]:ROSCillator:EXTernal:RFOFf[:STATe]
............................................................. 775
[:SOURce]:ROSCillator:EXTernal:SBANdwidth
................................................................. 775
[:SOURce]:ROSCillator[:INTernal]:ADJust:VALue
..............................................................776
[:SOURce]:ROSCillator[:INTernal]:ADJust[:STATe]
............................................................776
[:SOURce]:ROSCillator:SOURce
..................................................................................... 776
SOURce Subsystem