R&S SMJ100A, Operating Manual

Page: 274 / 874

Instrument Function
R&S
®
SMJ100A
258 Operating Manual 1403.7458.32 ─ 14
Example:
SOUR:LFO:SWE:FREQ:MODE AUTO
TRIG:LFFS:SWE:SOUR SING
TRIG:LFFS
Remote command:
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute
on page 741
:TRIGger<hw>:LFFSweep:IMMediate
on page 806
:TRIGger<hw>:LFFSweep
on page 805
:TRIGger<hw>[:IMMediate]
on page 809
Reset Sweep
Resets a sweep.
With the next trigger event, the sweep starts with at the initial value.
Remote command:
[:SOURce<hw>]:SWEep:RESet[:ALL]
on page 787
Start Freq
Sets the start frequency.
Remote command:
[:SOURce<hw>]:LFOutput:FREQuency:STARt
on page 739
Stop Freq
Sets the stop frequency.
Remote command:
[:SOURce<hw>]:LFOutput:FREQuency:STOP
on page 740
Current Freq
Displays the current frequency.
In sweep "Step" mode, the parameter is editable and you can enter frequency for the
next step.
Remote command:
[:SOURce<hw>]:LFOutput:FREQuency:MANual
on page 738
Spacing
Selects the mode for the calculation of the frequency sweep intervals.
"Linear" Takes the frequency value entered as an absolute value in Hz
"Logarithmic" Takes the value entered as a lograithmic value, that means as a con-
stant fraction of teh current frequency in
%
.
Remote command:
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing
on page 744
Shape
Selects the waveform shape of the sweep signal.
RF Signal and Analog Modulations - RF Block