R&S SMJ100A, Operating Manual

Page: 757 / 874

Remote Control Commands
R&S
®
SMJ100A
741 Operating Manual 1403.7458.32 ─ 14
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl <Dwell>
Sets the dwell time for each frequency step of the sweep.
Tip: It is recommended to switch off the "Display Update" for optimum sweep perform-
ance especially with short dwell times ( SYSTem:DISPlay:UPDate OFF ).
Parameters:
<Dwell> float
Range:
see data sheet: Dwell time setting range
Increment: 100E-6
*RST:
15E-3
Example: LFO:SWE:DWEL 20 ms
sets a dwell time of 20 ms.
Manual operation: See "Dwell Time - LF Sweep" on page 259
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute
Immediately starts an LF frequency sweep in LFO:SWE:MODE SINGle .
Example: LFO:SWE:MODE SING
sets the single cycle mode of the LF sweep.
LFO:SWE:EXEC
starts one cycle of the LF sweep.
Usage: Event
Manual operation: See "Execute Single Sweep" on page 257
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE <Mode>
Sets the cycle mode of the LF sweep.
The assignment of the GPIB commands to the sweep modes is given in the description
of the sweep dialogs.
SOURce Subsystem