Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 644 / 726

66. VLAN Trunking Commands
644
66.3. config vlan_trunk ports
 Description
This command is used to configure a port as a VLAN trunking port. By default, none
of the ports is a VLAN trunking port. A VLAN trunking port and a non-VLAN trunking
port cannot be grouped as an aggregated link. To change the VLAN trunking setting
for an aggregated link, the user must apply the command to the master port. If the
command is applied to link aggregation member port excluding the master, the
command will be rejected. Ports with different VLAN configurations are not allowed
to form an aggregated link. However, if they are specified as a VLAN trunking port,
they are allowed to form an aggregated link.
For a VLAN trunking port, the VLANs on which the packets can be by passed will not
be advertised by GVRP on this port. However, since the traffic on these VLANs is
forwarded, this VLAN trunking port should participate in the MSTP instances
corresponding to these VLANs.

Format
config vlan_trunk ports [<portlist> | all] | state [enable | disable]
 Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure ports 1 to 5 as VLAN trunking ports:
Zxxx0:admin#disable vlan_trunk
Command: disable vlan_trunk
Success.
Zxxx0:admin#
ports Specify the ports to be configured.
<portlist>
Specify the list of ports to be configured.
all Specify all ports will be configured.
state Specify the ports as VLAN or non-VLAN trunking ports.
enable
Specify the ports as VLAN trunking ports.
disable
Specify the ports as non-VLAN trunking ports.