Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 684 / 726

68. Web-based Access Control (WAC) Commands
684
68.4. config wac ports
 Description
This command is used to configure the WAC port parameters.

Format
config wac ports [<portlist> | all] {state [enable | disable] | aging_time [infinite | <min
1-1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}(1)

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To configure the WAC port state:
To configure the WAC port aging time:
<portlist>Specify a range of ports to configure.
all Specify to configure all ports.
state Specify to enable or disable the WAC state.
enable
Specify to enable the WAC state.
disable Specify to disable the WAC state.
aging_time
Specify a time period during which an authenticated host will be kept in authenticated
state. The default value is 1440 minutes.
infinite
Specify to indicate the authenticated host on the port will not ageout.
<min 1-1440> Specify an ageout value between 1 and 1440 minutes.
idle_timeSpecify a time period after which an authenticated host will be moved to un-
authenticated state if there is no traffic during that period. The default value is infinite.
infinite
Specify to indicate the host will not be removed from the authenticated
state due to idle of traffic.
<min 1-1440> Specify an idle time between 1 and 1440 minutes.
block_time
If a host fails to pass the authentication, it will be blocked for this period of time before it
can be re-authenticated.The default value is 60 seconds.
<sec 0-300>
Specify a block time between 0 and 300 seconds.
Zxxx0:admin#config wac ports 1-8 state enable
Command: config wac ports 1-8 state enable
Success.
Zxxx0:admin#