Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 484 / 726

51. Ring Redundant Protocol (RRP) Commands
484
51.Ring Redundant Protocol (RRP)
Commands
Ring Redundant Protocol (RRP) realizes to make a redundant network via ring
topology to recover the communication failure quickly, when the device or link
failure is happened.
One ring topology unit is called “domain”, RRP controller is called “Master node”,
and the other RRP members are called “Transit node”. “Master node” must be
existed only one node in domain.
Each domain require two VLANs: “Control VLAN” for RRP control, and “Data
VLAN” for actual data communication networks.
Figure 51-1 RRP overview
config rrp domain <domain name> [type {master|transit}] [control_vlan_id <vid>] [data_vlan_id
<vid list>] [primary_port <port num>] [secondary_port <port num>] [polling_interval <1-2sec>]
[fail_period <2-5sec>] [ring_guard_port {primary|secondary|both|disable}]
create rrp domain <domain name> type {master|transit} control_vlan_id <vid> data_vlan_id <vid
list> primary_port <port num> secondary_port <port num> [polling_interval <1-2sec>]
[fail_period <2-5sec>] [ring_guard_port {primary|secondary|both|disable}]
delete rrp domain <domain name>
disable rrp
disable rrp domain <domain name>
enable rrp
enable rrp domain <domain name>
show rrp
show rrp status