Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 439 / 726

46. Packet Storm Commands
439

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To configure the auto recover time to 5 minutes:
46.3. config traffic control log state

Description
This command is used to configure the traffic control log state. When the log state is
enabled, traffic control states are logged when a storm occurs and when a storm is
cleared. If the log state is disabled, traffic control events are not logged.
The log state is only applicable for shutdown mode. Since shutdown mode only support
broadcast and multicast storm control, doesn't support unicast storm control. The log only
generate for broadcast and multicast storm control.
 Format
config traffic control log state [enable | disable]

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
<min 0> Enter the automatic recovery time used here. This value will specifies the time to be 0
otherwise known as 'no recovery mode'.
<min 1-65535>
Enter the automatic recovery time used here. This value must be between 1 and 65535
minutes.
Zxxx0:admin# config traffic control auto_recover_time 5
Command: config traffic control auto_recover_time 5
Success.
Zxxx0:admin#
state Specifies the traffic control log state.
enable
Specifies that traffic control state will be logged when a storm occurs.
disable
Specifies that the traffic control state will be disabled.