Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 590 / 726

63. Utility Commands
590
63.4. upload
 Description
This command is used to upload a firmware or a configuration file from device to
TFTP server.
 Format
upload [cfg_toTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file
<path_filename 64> {unit <unit_id 1-4>} {src_file <pathname>} {[include | exclude |
begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude |
begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude |
begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}}}}} | log_toTFTP
[<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file <path_filename 64> |
attack_log_toTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file
<path_filename 64> {unit <unit_id 1-4>} | firmware_toTFTP [<ipaddr> | <ipv6addr> |
<domain_name 255>] dest_file <path_filename 64> {unit <unit_id 1-4>} {src_file
<pathname>}]
 Parameters
cfg_toTFTP
Used to upload a configuration file from a device to a TFTP server.
<ipaddr>
Specify the IP address of the TFTP server.
<ipv6addr>
Specify the IPv6 address of the TFTP server.
<domain_name 255>
Enter the domain name of the TFTP server here. This name can be up to 255
characters long.
dest_file Specify the path name on the TFTP server. It can be a relative path name or an absolute
path name
<path_filename 64>
Specify the location of the Switching Hub configuration file on the TFTP server. This
file will be replaced by the uploaded file from the Switching Hub. The maximum
length is 64 characters.
unit (Optional) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id 1-4>
Enter the unit ID used here.
src_file (Optional) Specify an absolute path name on the device file system. If a path name is not
specified, it refers to the boot up configuration file.
<pathname>
Specify the location of the Switching Hub configuration file on device.
include (Optional) Includes lines that contain the specified filter string.
exclude (Optional) Excludes lines that contain the specified filter string.