Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 565 / 726

58. Switch Port Commands
565
Please disable EEE status first if change the port mode from auto to others.
The combo ports (up-link) can not set to half-duplex mode.

Restrictions
Only Administrator and Operator-level users can issue this command.
 Example
To configure the speed of ports 1 to 3 to be 10 Mbps, with full duplex, learning enabled,
state enabled, and flow control enabled:
state Enable or disable the state of the specified port. If the ports are in error-disabled status,
configuring their state to enable will recover these ports from a disabled to an enabled
state. The default value is enable.
enable
Enable the specified port(s).
disable
Disable the specified port(s).
mdix Specify the type of cabling. The default value is auto.
auto Select auto for auto sensing of the optimal type of cabling.
normal
Select normal for normal cabling. If set to normal state, the port is in MDI mode
and can be connected to a PC NIC using a straight-through calbe or a port (in MDI
mode) on another Switching Hub through a cross-over cable.
cross Select cross for cross cabling. If set to cross state, the port is in MDIX mode, and
can be connected to a port (in MDI mode) on another Switching Hub through a
straight cable.
description
(Optional) Describe the port interface.
<desc 1-32>
Describe the port interface.
clear_description
(Optional) Deletes the present description of the port interface.
Zxxx0:admin#config ports 1-3 speed 10_full state enable learning enable
flow_control enable
Command: config ports 1-3 speed 10_full state enable learning enable flow_control
enable
Success.
Zxxx0:admin#
ワヰヵユ ワヰヵユ
ワヰヵユ ワヰヵユ