Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 132 / 726

17. Didital Diagnostic Monitoring (DDM) Commands
132
17.Didital Diagnostic Monitoring (DDM)
Commands
17.1. config ddm ports
temperature_threshold

Description
This command is used to configure the thresholds of temperature of the specified ports.
The command configures the temperature thresholds of the specified ports. The precision
of the effective threshold is dependent on the hardware.

Format
config ddm ports [<portlist> | all] temperature_threshold { high_alarm <degrees> |
low_alarm < degrees > | high_warning < degrees > | low_warning < degrees > } (1)
 Parameters
config ddm ports [ <portlist> | all ] [[temperature_threshold{ high_alarm <degrees> | low_alarm
<degrees> | high_warning <degrees> | low_warning <degrees>}|voltage_threshold{
high_alarm <voltage> | low_alarm <voltage> | high_warning <voltage> |
low_warning<voltage>} | bias_current_threshold { high_alarm <milliampere> | low_alarm
<milliampere> | high_warning <milliampere> | low_warning<milliampere>} |
tx_power_threshold{ high_alarm <mw_or_dbm> | low_alarm <mw_or_dbm> |
high_warning <mw_or_dbm> | low_warning<mw_or_dbm>} | rx_power_threshold{
high_alarm <mw_or_dbm> | low_alarm <mw_or_dbm> | high_warning <mw_or_dbm> |
low_warning <mw_or_dbm>}] | {state [enable|disable] | shutdown [alarm | warning |
none]}]
config ddm [trap | log] [enable|disable]
config ddm power_unit [mw|dbm]
show ddm
show ddm ports {<portlist>} [status|configuration]
ports
<portlist>
Specifies a range of ports to be configured. (The portlist format: UnitID: port
number).
all If 'all' parameter is chosen, all optic ports' operating parameters will be configured.
temperature_threshold
Specifies the threshold of the optic module's temperature in centigrade. At least one
parameter shall be specified for this threshold.