Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 485 / 726

51. Ring Redundant Protocol (RRP) Commands
485
51.1. config rrp domain
 Description
This command is used to configure the RRP domain.

Format
config rrp domain <domain name> [type {master|transit}] [control_vlan_id <vid>]
[data_vlan_id <vid list>] [primary_port <port num>] [secondary_port <port num>]
[polling_interval <1-2sec>] [fail_period <2-5sec>] [ring_guard_port
{primary|secondary|both|disable}]

Parameters
<domain name>
Specify the domain name of the RRP domain with 1-25 characters.
type
Specify the RRP node type.
master
Specify the RRP node as Master. The Master node must be existed only one in
domain.
transit
Specify the RRP node as Transit.
control_vlan_id
Specify the control VLAN ID.
<vid>
Specify the control VLAN ID between 2-4094. The existed VLAN ID is not allowed
to use.
data_vlan_id
Specify the data VLAN ID.
<vid list>
Specify the data VLAN ID(s) between 1-4094. You can use a comma (,) or hyphen
(-) for multiple assignment.
primary_port
Specify the primary port to connect with other nodes.
<port num>
Specify the port number.
secondary_port
Specify the secondary port to connect with other nodes.
<port num>
Specify the port number.
polling_interval
Specify the polling interval time to send RRP control frame to next node. The factory
default is 1 sec.
<1-2 sec>
Specify the time between 1 and 2 seconds.
polling_interval and fail_period are not allowed to set the same value.