Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 155 / 726

18. Debug Software Command List
155

Parameters

Restrictions
Only Administrator-level users can issue this command.

Example
To set all module debug message outputs to local console:
18.4. debug config error_reboot

Description
This command is used to set if the Switching Hub needs to be rebooted when a fatal error
occurs. When the error occurs, the watchdog timer will be disabled by the system first, and
then all debug information will be saved in NVRAM. If the error_reboot is enabled, the
watchdog shall be enabled after all information is stored into NVRAM.

Format
debug config error_reboot [enable | disable]

Parameters

Restrictions
Only Administrator-level users can issue this command.
module Specifies the module list.
<module_list>
Enter the module list here.
all Control output method of all modules.
buffer Direct the debug message of the module output to debug buffer(default).
console Direct the debug message of the module output to local console.
Zxxx0:admin# debug output all console
Command: debug output all console
Success.
Zxxx0:admin#
enable Need reboot Switching Hub when fatal error happens.(if the project do not define the
default setting, enable for default).
disable Do not need reboot Switching Hub when fatal error happens, system will hang-up for
debug and enter the debug shell mode for debug.