Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 374 / 726

41. MLD Snooping Commands
374
41.5. config mld_snooping static_group
 Description
This command is used to configure an MLD snooping static group on the Switching Hub.
When a port is configured as a static member port, the MLD protocol will not operate on
this port. Therefore, suppose that a port is a dynamic member port learned by MLD. If this
port is configured as a static member later, then the MLD protocol will stop operating on
this port. The MLD protocol will resume once this port is removed from static member
ports. The static member port will only affect V1 MLD operation.

Format
config mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
[add | delete] <portlist>

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To unset ports 9 to 10 from MLD Snooping static member ports for group FF1E::1 on
default VLAN:
Zxxx0:admin#create mld_snooping static_group vlan vlan1 FF1E::1
Command: create mld_snooping static_group vlan vlan1 FF1E::1
Success.
Zxxx0:admin#
vlan Specify the name of the VLAN on which the static group resides.
<vlan_name 32>
Specify the VLAN name. The maximum length is 32 characters.
vlanid Specify the ID of the VLAN on which the static group resides.
<vlanid_list>
Specify the VLAN ID list.
<ipv6addr>
Specify the multicast group IPv6 address (for Layer 3 Switching Hub).
add Specify to add the member ports.
delete Specify to delete the member ports.
<portlist>Specify a range of ports to be configured.