Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 105 / 726

11. Bootup Function Commands
105

Example
To show boot_file
11.2. config boot_up command

Description
This command is used to config the boot_up command.
1. The parameter "<pathname>" can specifies file on either SD card or flash.
Pathname of the boot up file will be recorded in the system after issue the
commands above. And the 2nd boot up files can be shown by command "show
boot_file".
2. When use "config firmware image <pathname> boot_up" or "config configuration
<pathname> boot_up" commands, will check the file indicated by <pathname> is
existed or valid for boot up. If the file is not existed or not valid for boot up,
executing command will be failed.
3. The 2
nd
Bootup Firmware/Configuration will not be changed until using
command to configure it. That means it will not clear the 2
nd
Bootup Firmware/
Configuration pathname when it is saved in SD card even though the SD card is
pushed out or insert SD card no this boot file or system is rebooted.
4. For 2
nd
Bootup Firmware or 2
nd
Bootup Configuration, the factory default boot
up file should be: /c:/runtime.rom, /c:/config.cfg.
 Format
config firmware image <pathname> boot_up
config configuration <pathname> boot_up

Parameters
None.
Zxxx0:admin#show boot_file
Command: show boot_file
*1st Bootup Firmware : /d:/sd_runtime.rom
*1st Bootup Configuration : /d:/sd_config.cfg
*Can not change 1st Bootup File
2nd Bootup Firmware : /c:/runtime.rom
2nd Bootup Configuration : /c:/config.cfg
Actual Bootup Firmware : /c:/runtime.rom
Actual Bootup Configuration : /c:/config.cfg
SD card: d drive, FLASH: c drive
Zxxx0:admin#