Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 153 / 726

18. Debug Software Command List
153
18.2. debug buffer
 Description
Use this command to show the debug buffer's state, or dump, clear, or upload the
debug buffer to a TFTP server.
When selecting to output to the debug buffer and there are debug
messages being outputted, the system memory pool will be used as the
debug buffer. The functions which will use the system memory pool
resource may fail to execute command such as download and upload
firmware, or save configuration. If you want to execute these commands
successfully, please use the command "debug buffer clear" to release the
system's memory pool resources manually first.

Format
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename
64>]
 Parameters

Restrictions
Only Administrator-level users can issue this command.

Example
To show the debug buffer's state:
utilization
Display the debug buffer's state.
dump Display the debug message in the debug buffer.
clear Clear the debug buffer.
upload_toTFTP
Upload the debug buffer to a TFTP server specified by IP address.
<ipaddr>
Specifies the IPv4 address of the TFTP server.
<path_filename 64>
The pathname specifies the DOS pathname on the TFTP server. It can be a relative
pathname or an absolute pathname. This value can be up to 64 characters long.
ワヰヵユ ワヰヵユ