Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 94 / 726

10. Basic IP Commands
94
10.Basic IP Commands
In this chapter, you will configure the IP address settings.

IPv6 Link-Local address
In general, if an IPv6 address is not configured, the link-local address is also not
configured. When the automatic configuration of link-local address is enabled, the
link-local address is automatically configured even though an IPv6 address is not
configured, allowing for communications in the local network.
For the default gateway settings, refer to the sections in "IP Routing
Commands."
 IP Setup Interface
Our free application “ZEQUO assist” provides an easy-to-use user interface to
change the IP address.
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name32> | state
[enable | disable]} bootp | dhcp | ipv6 [ipv6address <ipv6networkaddr> | state [enable
| disable]] | ipv4 state [enable | disable] | ip_directed_broadcast [enable |disable] |
dhcpv6_client [ enable | disable]]
delete ipif <ipif_name 12> ipv6address <ipv6networkaddr>
enable ipif <ipif_name 12>
disable ipif <ipif_name 12>
show ipif {<ipif_name 12>}
enable ipif_ipv6_link_local_auto <ipif_name 12>
disable ipif_ipv6_link_local_auto <ipif_name 12>
show ipif_ipv6_link_local_auto {<ipif_name 12>}
enable ip_setup_interface
disable ip_setup_interface
show ip_setup_interface
ワヰヵユ ワヰヵユ