31. Jumbo Frame Commands
274
31.Jumbo Frame Commands
In Ethernet, communication data is divided into fixed-size units called
"frames" and transmitted. The standard frame has a fixed-size of 1518
bytes. A frame called jumbo frame is larger than the standard frame
for more efficient data transmission.
This Switching Hub supports a jumbo frame with up to 9000 bytes and
allows you to configure the setting for all ports or each port.
To transmit with jumbo frames, all devices on the route, including this
Switching Hub, must support jumbo frames. If there are some devices
not supporting jumbo frames, data is transmitted with the standard
frame size.
Figure 31-1 Jumbo frame overview
enable jumbo_frame
disable jumbo_frame
config jumbo_frame ports [<portlist> | all] state [enable | disable]
show jumbo_frame {<portlist>}
Summary of Contents for ZEQUO 2200
