Panasonic ZEQUO 2200, Operating Instructions Manual

Page: 316 / 726

36. LLDP Commands
316

Example
To display LLDP TLV option port 1:
36.9. config lldp_med fast_start repeat_count

Description
This command is used to configure the fast start repeat count. When an LLDP-MED
Capabilities TLV is detected for an MSAP identifier not associated with an existing
LLDP remote system MIB, the application layer shall start the fast start mechanism
and set the 'medFastStart' timer to 'medFastStartRepeatCount' times 1. The default
value is 4.
 Format
config lldp_med fast_start repeat_count <value 1-10>

Parameters

Restrictions
Zxxx0:admin#show lldp ports 1
Command: show lldp ports 1
Port ID : 1
--------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Disabled
Advertised TLVs Option :
Port Description Disabled
System Name Disabled
System Description Disabled
System Capabilities Disabled
Enabled Management Address
(None)
Port VLAN ID Disabled
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol Identity
(None)
MAC/PHY Configuration/Status Disabled
Link Aggregation Disabled
Maximum Frame Size Disabled
Zxxx0:admin#
<value 1-10>
Specify a fast start repeat count value between 1 and 10. The default value is 4.