167
Basic Setting for Ethernet
Section 6-4
1,2,3...
1.
Lay the twisted-pair cable.
2.
Connect the cable to the hub. Be sure to press in the cable until it locks into
place.
Request cable installation from a qualified professional.
3.
Connect the cable to the connector on the PLC. Be sure to press in the ca-
ble until it locks into place.
6-4
Basic Setting for Ethernet
6-4-1
Overview of Startup Procedure
Note
(1) The local IP address and other parameters can be set from the CX-Pro-
grammer.
(2) It is not necessary step, and the CX-Integrator version 2.53 or higher (CX-
ONE version 4.25 or higher) is required.
When the FINS communications service is used, routing tables must be
created in advance. Routing tables are required in the following circum-
stances.
• When communicating with a PLC or computer on another network
(e.g. remote programming or monitoring using FINS message or a CX-
programmer)
• When routing tables are used for one or more other nodes on the same
network
(3) It is not necessary step.
Determine the local IP address
and address conversion method.
Refer to
Ethernet Units Construction of Networks Operation Manual for CS/CJ Series
(Cat. No. W420-E1) SECTION 5 Determining IP Addresses.
Refer to
6-3 Network Installation.
Connect to the network
using twisted-pair cable.
Create the routing tables.
Perform PLC setup.
(Create IP router tables.)
Turn ON power to the CPU Unit.
(See note 1.)
(See note 2.)
(See note 3.)
Set the IP address freely with the
CX-Programmer.
Connecting to the CPU Unit
without making any settings.
Use auto connection method or
the default IP address.
Refer to
6-4-3 Basic Settings.
Refer to
Ethernet Units Construction of Networks Operation Manual for CS/CJ Series
(Cat. No. W420-E1) 6-4 Creating Routing Tables.
Refer to
6-4-3 Basic Settings.
Summary of Contents for CP1L-EL20DR-D
