Omron CP1L-EL20DR-D, Operation Manual

Page: 265 / 856

231
High-speed Counters Section 7-1
■ I/O Wiring
Input Wiring
Output Wiring
■
Range Comparison Table Settings
The inspection standards data is set in the DM Area with the CX-Programmer.
Even though range 1 is the only range being used, all 40 words must still be
dedicated to the range comparison table.
COM 01 03 05 07 09 11 01 03 05 07 09 11
00 02 04 06 08 10 00 02 04 06 08 10
Workpiece end detection
High-speed counter 0 (phase Z) Workpiece start detection
High-speed counter 0 (phase B)
Measurement
start switch
High-speed counter 0 (phase A)
Upper Terminal Block
+ -
NC
NC
NC
00 01 06
COM
05 07
CIO 100
CIO 101
CIO 100
CIO 101
PL1: OK indicator
PL2: NG indicator
Bottom terminal block
(Example: Relay Output
Models)
PL1
PL2
COM COM COM COM COM
03
02
04
06 01 02 03 04 00
05 07
Word Setting Function
D10000 7430 Rightmost 4 digits of range 1 lower limit Lower limit value:
30,000
D10001 0000 Leftmost 4 digits of range 1 lower limit
D10002 765C Rightmost 4 digits of range 1 upper limit Upper limit value:
30,300
D10003 0000 Leftmost 4 digits of range 1 upper limit
D10004 000A Range 1 interrupt task number = 10 (A hex)
D10005 to
D10008 All 0000 Range 2 lower and upper limit values
(Not used and don’t need to be set.)
Range 2 settings
D10009 FFFF Disables range 2.
~