83
Wiring CP1L-EL/EM CPU Units
Section 3-4
3-4-2
Wiring Built-in I/O
Wiring Precautions
Double-checking I/O
Specifications
Double-check the specifications for the I/O Units. In particular, do not apply a
voltage that exceeds the input voltage for Input Units or the maximum switch-
ing capacity for Output Units. Doing so may result in breakdown, damage, or
fire.
When the power supply has positive and negative terminals, always wire them
correctly.
Electric Wires
• AWG22 to AWG18 (0.32 to 0.82 mm
2
) power lines are recommended.
Use cable with a maximum diameter of 1.61 mm including the insulation
covering.
• The current capacity of electric wire depends on factors such as the ambi-
ent temperature and insulation thickness, as well as the gauge of the con-
ductor.
• M3 self-rising screws are used for all screw terminals including terminal
screws for crimp terminal power supply wiring.
• Use crimp terminals or solid wire for wiring.
• Do not connect bare stranded wires directly to terminals.
• Tighten the terminal block screws to the torque of 0.5 N·m.
• Use crimp terminals (M3) having the dimensions shown below.
Wiring
• Wire the Units so that they can be easily replaced.
• Make sure that the I/O indicators are not covered by the wiring.
• Do not place the I/O wiring in the same conduits or ducts as high-voltage
or power lines. Inductive noise can cause errors or damage.
• Tighten the terminal screws to the torque of 0.5 N·m.
6.2 mm max.
6.2 mm max.
6.2 mm max.
6.2 mm max.
Unit type
Terminal width
Terminal pitch
CPU Units
6.4 mm
7.6 mm
Expansion I/O Units
40ED
/32E
/20EDT
6.4 mm
7.7 mm
Expansion I/O Units
AD04
/DA0
/MAD
/TS
0
SRT21/20EDR1/16E
/8E
6.8 mm
8.4 mm
Terminal
width
Terminal
pitch
Summary of Contents for CP1L-EL20DR-D
