Omron CP1L-EL20DR-D, Operation Manual

Page: 463 / 856

429
Built-in Analog Input Section 8-4
Analog Input Terminal
Arrangement
Note The PV in the Auxiliary Area (A642) is for analog input 1.
The PV in the Auxiliary Area (A643) is for analog input 2.
Applicable Cables and
Terminal Wiring
■ Applicable Cables
Solid wire or ferrules can be used.
• Recommended solid wire
• Recommended ferrules
Note Do not connect bare stranded wires directly to terminals.
■
Terminal Wiring
When wiring the analog I/O terminal block, treat either solid or stranded wires
directly.
• To make the connection, press the release button in with a small flat blade
screwdriver and push the line in while the lock is released. Remove the
screwdriver and lock it inside.
• To disconnect the wiring, press the release button in with a small flat
blade screwdriver and pull the line out while the lock is released.
Note (1) Ferrules with/without plastic sleeve cannot be used.
(2) When using stranded wire, twist the core so that the barbed wires cannot
protrude.
(3) Do not solder-plate the end of cable.
The screwdriver shown below is recommended for wiring.
Voltage Input 1
Voltage Input 2
V1
V2
COM Input Common
V1 V2
A643
COM
A642
Wire type Wire size
Solid Wire
0.2mm 2 to 0.5mm 2 (AWG24 to AWG20)
Manufacturer Model Applicable wire
Phoenix Contact AI-0.5-10
0.5mm 2 (AWG20)
Release button
2-conductor shielded
twisted-pair cable
Model Manufacturer
SZS 0.4

2.5 Phoenix Contact