Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 373 / 500

14. USING A DIRECT DRIVE MOTOR
14 - 40
14.5.7 Option setting parameters (No.Po
)
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: After setting the parameter, cycle the power or reset the controller.
**: After setting the parameter, cycle the power.
No. Symbol Name
Each/
common
(Note 1)
Default
value
(Note 2)
Unit Reference
Po01 *OOP1 Function selection O-1 Common 0000h
Po02 SGRA Axis selection for graphing analog data (MR Configurator) Common 0000h
Section
5.5.2
Po03 SGRD Axis selection for graphing digtal data (MR Configurator) Common 0000h
Po04 **OOP2 Function selection O-2 Common 0000h
Po05 This parameter is not used. Do not change this value by any means. 0000h
Po06 0000h
Po07 0000h
Po08 0000h
Po09 0000h
Po10 0000h
Po11 0000h
Po12 0000h
Po13 0000h
Po14 0000h
Po15 0000h
Po16 0000h
Note 1. Each: Set parameters for each axis of A and B.
Common: Set parameters for common axis of A and B. Be sure to set the same value to the both axes. When the setting values are
different, the value set at last will be enabled.
2. The values are common in A-axis and B-axis.