Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 263 / 500

13. USING A LINEAR SERVO MOTOR
13 - 14
13.5 Operation and functions
13.5.1 Startup
POINT
To use a linear servo motor, turn SW3 on.
F
ront
s
ide
SW3
1
ON
A-axis
B-axis
2
(1) Startup procedure
Start up the linear servo referring to the following procedure.
Incremental linear encoder
Absolute position linear encoder
Execution of installation and wiring
(Note) Settings of the linear encoder direction and the linear servo motor
direction (Refer to (3) in this section.)
(Note) Setting of the linear encoder resolution (Refer to (4) in this section.)
(Note) Execution of the magnetic pole detection (Refer to section
13.5.2 (3).)
(Note) Positioning operation check (Refer to section 13.5.4.)
Positioning operation check using the controller (Refer to section 13.5.5.)
Home position return (Refer to section 13.5.3.)
Positioning operation
Change to the setting not requiring the magnetic
pole detection (Refer to section 13.5.2 (3).)
What is the type
of linear encoder?
Setting of the servo motor selection switch (SW3) (Refer to section 3.14.)
Set the linear servo motor series and linear servo motor type.
(Refer to (2) of this section.)
Note. MR Configurator is used.