Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 375 / 500

14. USING A DIRECT DRIVE MOTOR
14 - 42
Alarm deactivation
Display Name Power off
to on
Error
reset
CPU reset
Detection
system
(Note 3)
Stop
system
(Note 4)
46 Direct drive motor overheat
(Note 1) (Note 1) (Note 1)
Each Each
47 Cooling fan error Common All axes
50 Overload 1
(Note 1) (Note 1) (Note 1)
Each Each
51 Overload 2
(Note 1) (Note 1) (Note 1)
Each Each
52 Error excessive Each Each
8A USB communication time-out error Common All axes
8E USB communication error Common All axes
Ala
rm
888 Watchdog Common All axes
91 Main circuit device overheat warning Common
92 Battery cable disconnection warning Each
96 Home position setting warning Each
9F Battery warning Each
E0 Excessive regeneration warning Common
E1 Overload warning 1 Each
E2 Direct drive motor overheat warning Each
E3 Absolute position counter warning Each
E4 Parameter warning Each
E6 Servo forced stop warning Common All axes
E7 Controller forced stop warning Common All axes
E8 Cooling fan speed reduction warning Common
E9 Main circuit off warning Common All axes
EB The other axis error warning Each All axes
EC Overload warning 2 Each
Warni
ng
ED Output watt excess warning Each
Note 1. Wait for about 30 minutes as cooling time after removing the cause of occurrence, then deactivate the
alarm.
2. In some controller communication status, the alarm factor may not be removed.
3. Indicates detected axis of alarm/warning.
Each: Alarm/warning will be detected for each axis.
Common: Alarm/warning will be detected as a common axis.
4. When an alarm/warning occurs, following axis will stop.
Each axis: Only detected axis will stop.
All axes: All axes will stop.
5. To cancel it, set parameter No.PS04 to "1 ".