Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 104 / 500

5. PARAMETERS
5 - 17
5.3 Extension setting parameters (No.PC
)
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.
5.3.1 Parameter list
No. Symbol Name
Setting
(Note 1)
Factory
setting
(Note 2)
Unit
PC01 ERZ Error excessive alarm level Each axis 0 rev
PC02 MBR Electromagnetic brake sequence output Each axis 0 ms
PC03 *ENRS Encoder output pulses selection Each axis 0010h
PC04 **COP1 Function selection C-1 Each axis 0000h
PC05 **COP2 Function selection C-2 Each axis 0000h
PC06 *COP3 Function selection C-3 Each axis 0000h
PC07 ZSP Zero speed Each axis 50 r/min
PC08 This parameter is not used. Do not change the value. 0
PC09 MOD1 Analog monitor 1 output Common 0000h
PC10 MOD2 Analog monitor 2 output Common 0001h
PC11 MO1 Analog monitor 1 offset Common 0 mV
PC12 MO2 Analog monitor 2 offset Common 0 mV
PC13 This parameter is not used. Do not change the value. 0
PC14 0
PC15 SNO Station number selection Common 0
PC16 This parameter is not used. Do not change the value. 0000h
PC17 **COP4 Function selection C-4 Each axis 0000h
PC18 This parameter is not used. Do not change the value. 0000h
PC19 0000h
PC20 0000h
PC21 *BPS Alarm history clear Each axis 0000h
PC22 This parameter is not used. Do not change the value. 0000h
PC23 0000h
PC24 0000h
PC25 0000h
PC26 0000h
PC27 0000h
PC28 0000h
PC29 0000h
PC30 0000h
PC31 0000h
PC32 0000h
Note 1. Each axis: Set a value for each of the A-axis and the B-axis.
Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are
set, the last set value becomes valid.
2. Valid for the A-axis and the B-axis.