Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 305 / 500

13. USING A LINEAR SERVO MOTOR
13 - 56
No. Symbol Name Setting
Factory
setting
Unit
Setting
range
PS10 This parameter is not used. Do not change the value. 5
PS11 100
PS12 500
PS13 0000h
PS14 0
PS15 0000h
PS16 0000h
PS17 LTSTS Minute position detection method function selection
Used to set the response and the load to motor mass ratio of the minute position
detection method.
To make the parameter valid, set parameter No.PS08 (Linear function selection 3)
to "
4" (minute position detection method). (Refer to (4)(b) in section 13.5.2.)
Low response
High response
Response of the minute position detection method
Selecting the load to mass of the linear servo motor
primary side (coil) ratio, which decides the response of
the minute position detection method
0 0
Setting Response Setting Response
0 8
1 9
2 A
3 B
4 C
5 D
6 E
7 F Medium response
Medium response
Setting
Load to motor
mass ratio
Setting
7 F 150 times or more 70 times
0 8
1 9
2 A
3 B
4 C
5 D
6 E
Less than 10 times 80 times
90 times
10 times
100 times 20 times
110 times 30 times
120 times 40 times
130 times 50 times
140 times 60 times
Load to motor
mass ratio
Each
axis
0000h Refer to
name
and
function
column.
PS18 IDLV Minute position detection method identification signal amplitude
Used to set the identification signal amplitude for the minute position detection
method. To make the parameter valid, set parameter No.PS08 (Linear function
selection 3) to "
4". Identification signal is "100 " when "0" is set. (Refer to
(4)(b) in section 13.5.2.)
Each
axis
0000h 0000h
to
006Fh
PS19 This parameter is not used. Do not change the value. 0000h
PS20 0000h
PS21 0000h
PS22 0000h
PS23 0000h
PS24 0000h
PS25 0000h
PS26 0000h